+8618879561688

sales@pcbsupplier.com

Sign in
X
2022-03-14 1075
Panel Requirements for PCB Assembly
Omni pcb does PCB Assembly panel production with min size 50*50mm, max size 310*410mm. We can manufacture circuit boards based on your panelized PCB file. If you only have single PCB file, we can help panelize design according to your specific demands, then manfuacture the boards. Feel free to send us a message if you need assistance in PCB Assembly panel, we’ll react accordingly.

1. Panel with V-CUT/V-GROOVE We require 0.0mm spacing between each unit for panel with V-cut, following image for your reference.

As the V-scoring could only go all through the whole board and no-stop, V-cut cannot be used for the panel with units of different size. Take the following panel for an example, we would recommend Tab-routing instead of V-cut. 2. Panel with TAB-ROUTE For panel with Tab-route, we need 2.0mm spacing between each unit. We offer two options for tab-routing: Tab-Route with breaking holes and Tab-route with tabs.

• Tab-Route with breaking holes

• Tab-route with tabs, the width of tabs should be 1.0mm.

3. Panel with both V-CUT and ROUTE Fiducial For panel with both V-cut and Route fiducial, we require 2.0mm spacing between each unit. Please refer the following image to design the panel.
1. Fiducial marks For each panel, we require at least 3 fiducial marks. Those marks should be placed in the middle of the tooling strips with the diameter at 1.0mm.

The fiducial marks on board’s left should be 10.0mm away from the board edge, and the right ones should be 15.0mm away from the board’s right edge. Following image is for your reference. 2. Mounting holes We would recommend diameter of mounting holes to be set at 3.0mm and the width of tooling strips at 7.0mm, and at least 5.0mm distance from the edge of the board. Check the image below for reference.

Connect to a OMNI PCB engineer to support your project!

Request A Quote
Quote
E-mail Skype Whatsapp